Panasonic FZ-G1 Series Operating Instructions Manual page 28

Installing Software
D Touch [Restart] of the "Manage the TPM security hardware" screen.
The computer will restart.
E When "TPM configuration change was requested to ..." is displayed, press F12 .
Windows will start.
F When "TPM is ready" appears, touch [Close].
1 Turn on the computer, and press
screen is displayed.
The Setup Utility starts up.
l If the [Panasonic] boot screen is not displayed, turn on the computer while holding down
F2 or Del .
l If the password is requested, enter the Supervisor Password.
2 Write down all of the contents of the Setup Utility and press
At the confirmation message, select [Yes] and press Enter .
3 Press
F10
At the confirmation message, select [Yes] and press Enter .
Computer will restart.
4 Press
F2
The Setup Utility starts up.
l If the password is requested, enter the Supervisor Password.
5 Select the [Exit] menu, then select [Recovery Partition] and press
6 Touch [Reinstall Windows] and touch [Next].
The License Agreement screen appears.
7 Touch [YES].
The License Agreement screen appears.
8 Touch [Yes, I agree to the provisions above and wish to continue!] and
touch [Next].
9 Select the setting and touch [Next].
l [Reinstall Windows to the whole Hard Disk to factory default.]
Select this option when you want to install Windows to the factory default. After instal-
lation, you can create a new partition. For how to create a new partition, refer to "To
change the partition structure" (è page 21).
l [Reinstall to the System and OS partitions.]
Select this option when the flash memory has already been divided into several parti-
tions. For how to create a new partition, refer to "To change the partition structure" (è
page 21).
You can keep the partition structure.
*1
This does not appear if Windows cannot be installed to the recovery partition and the area us-
able by Windows.
10 At the confirmation message, touch [YES].
11 Select OS (32bit or 64bit) and touch [OK].
12 At the confirmation message, touch [YES].
Installation starts according to the instructions on the screen. (It will take approximately 20
minutes.)
l Do not interrupt installation, for example by turning off the computer or pressing Ctrl +
Alt + Del .
28
.
or while [Panasonic] boot screen is displayed.
Del
or while [Panasonic] boot
F2 Del
*1
.
F9
.
Enter