Removing The Rear Cover Unit; Removing The Side Cover; Removing The Lcd Unit - Sharp UP-X500 Installation Manual

Precautions
• Before installation, be sure to turn off the power.
• Use gloves to protect your hands from being cut by the angle and
the chassis.
• Connect all the cables securely. When connecting or disconnecting
the cables, be careful not to apply stress to the cables. (It may
cause disconnection.)
• Ground the human body to prevent against troubles and dust adhe-
sion to the LCD by static electricity. When assembling the LCD, use
a discharge blower to prevent against dust intrusion.
• Be careful of the high voltage of the inverter PWB transformer.
• Place the top cabinet with LCD panel side down, Please use a clean
dust free clothe to protect the touch panel and LCD area.

1. Removing the rear cover unit

Remove the screw 1 , and remove the rear cover unit 2 .
1

2. Removing the side cover

Slide the lever 1 to release the lock. Slide the side cover 2 toward
you and rotate and remove it.
2
1

3. Removing the LCD unit

3-1. Removing the top cover section
1
3-2. Removing the Top cover unit
Caution: Top cover unit 7 is pushed down.
2
1. Remove the screw 1 , and remove the wire holder 2 .
2. Remove the screw 3 , and remove the wire holder 4 .
3. Remove the core 5 of the T/P cable.
4. Remove four screws 6 , and disassemble the top cover unit 7 .
UP-X500I Removing the rear cover unit
– 1 –
Remove each screw 1 , and lift the rear side of the top cover
section 3 and disconnect each connector
1
1
1
[Screw 1 is Black.]
1
2
7
6
2 and remove.
3
2
2
1
5
3
4
6