Washer Maintenance - Kenmore 2130 Series Use & Care Manual

Top-loading; high efficiency; low-water
Hide thumbs Also See for 2130 Series:
Table of Contents

Advertisement

Available languages

Available languages

WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
monthly cleaning procedure:
1. Make sure the washer is empty.
2. Using liquid chlorine bleach, add 1 cup (250 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER with
bleach cycle. Do not use more than recommended amount of
bleach to avoid damaging product over time.
3. Close washer lid.
4. Select CLEAN WASHER with bleach cycle.
5. Select HOT Wash Temp.
6. Press START/PAUSE/Unlock Lid. Water will pour into
washer for a moment and pause, lid will lock, unlock, then
cycle will continue.
NOTE: For best results, do not interrupt cycle. If cycle must
be interrupted, Press and Hold START/PAUSE/Unlock Lid for
three seconds and run a RINSE/SPIN cycle to ensure bleach
has been rinsed from washer.
Cleaning the bleach dispenser
Wipe the inside of the bleach dispenser with a clean,
damp cloth.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use all-purpose surface cleaner, if needed.
IMPORTANT: To avoid damaging the washer's finish,
do not use abrasive products.

WASHER MAINTENANCE

Operate your washer only when you are home. If moving,
or not using your washer for a period of time, follow these
steps:
1. Unplug or disconnect power to washer.
2. Turn off water supply to washer, to avoid flooding due
to water pressure surge.
IMPORTANT: To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1. Shut off both water faucets; disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on RINSE/SPIN cycle for about 30 seconds to
mix antifreeze and remaining water.
3. Unplug washer or disconnect power.
NON-USE AND VACATION CARE
WINTER STORAGE CARE
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents