Adjusting The Picture Position - Sony VPL-HW65 Operating Instructions Manual

Adjusting the Picture
Position
Project an image on the screen and then
adjust the picture position.
Tip
? 1
The / (ON/STANDBY), INPUT, MENU,
and M/m/</,/
side panel of the unit function the same as those
on the remote control.
Note
Depending on the installation location of the
unit, you may not be able to control it with the
remote control. In this case, point the remote
control to the screen instead of the projector.
1
After connecting the AC power cord to
the unit, plug the AC power cord into
a wall outlet.
Remote control
detector
(joystick) buttons on the
The ON/STANDBY indicator lights in
red and the unit goes into standby mode.
2
Press the ?/1 (ON/STANDBY) button
to turn on the unit.
The ON/STANDBY indicator flashes in
green, and then lights in green.
3
Display a test signal for performing
adjustments.
Press the PATTERN button on the
remote control to display the test signal.
Tip
Press the PATTERN button to clear the test
signal display.
8
Lights in red.
Flashes in green for
a while (tens of
seconds) and then
lights in green.