Tip: Relax, you can't overcharge your battery.
It will perform best after you fully charge and
discharge it a few times.
Note: You can charge your battery
by connecting a cable from your
phone's mini-USB port to a USB
port on a computer. Both your
phone and the computer must be turned on,
and your computer must have the correct
software drivers installed. Cables and
software drivers are available in
Motorola Original data kits, sold separately.
turn phone on & off
Caution: The phone may ask for your
SIM card PIN code when you turn it on. If you
enter an incorrect PIN code three times
before the correct code, your SIM card is
disabled, and your display shows SIM Blocked.
Contact your service provider.
To turn on your phone,
press and hold the
power/end key O until
the keypad or display
lights up. If prompted,
enter your eight-digit
SIM card PIN code and/or four-digit unlock
code.
To turn off your phone, press and hold O for
a few seconds.
make a call
Open the slider, then enter a phone number
and press the send key N to make a call.
To voice dial a call, see page 53.
To "hang up, " close the slider or press the
power/end key O.
essentials
21