Midland D-200 Instruction Manual page 15

Problem
It is not possible to
communicate with
other parties
Reception is fragmen-
ted and/or disturbed
The autonomy of the
battery pack is limited
Midland D-200 instruction guide
Possible Cause
Incorrect CTCSS or
DCS
The signal is very
weak.
The transmission
distance is exces-
sive and/or there
are obstacles in the
transmission path
Other parties are
using the same
channel
The radio has been
installed too close
to equipment that
causes interference
(televisions, compu-
ters, etc.)
Transmission time is
too high.
Solution
Check that the CTCSS
tone or DCS code
corresponds to the
one set by the parties
you are communica-
ting with.
Try temporarily disa-
bling the Squelch by
means of the Monitor
feature.
Move closer to the
party you are com-
municating with or to
another area.
Check the traffic on
the radio channel by
means of the Monitor
feature and select
another channel if
required.
Increase the distance
between the radio
and this equipment.
Try reducing the
transmission time
and/or using a low
power.
| 13