GEM PTZ722 Installation And Operation Manual page 6

8. F1 ............................
9. ADDR ....................... Camera address number set in camera
10. MENU ........................ System and Dome setup (see later info)
11. IRIS + ........................ Increase aperture / Open
12. IRIS - .......................... Decrease aperture / Close
13. SHOT .......................... Call a preset e.g Shot <no.> Enter
14. F2 ............................ Run Pattern
15. Joystick ....................... Left, right, up, down, twist to zoom in/out,
16. Joystick Button ............
LCD DISPLAY
On the back of the keyboard there are three video input BNC connections. These are for connecting
video from three separate cameras that can be individually selected using the Shift button. The
video channel will relate to video channel connected to the back of the keyboard. A display of the
channel number will be shown for approximately 15 seconds as shown below:
Pattern setup
for PTZ continuous rotation.
VIDEO – 1
DOME – 8 P:PELCOD B:2400 DA:
6