Page 3
1. WORK AREA Definitions: Safety Guidelines a. Keep work area clean and well lit. Cluttered and dark areas invite accidents. The definitions below describe the level of severity for each signal word. Please b. Do not operate power tools in explosive atmospheres, such as in the read the manual and pay attention to these symbols.
b. Use personal protective equipment. Always wear eye protection. Safety operation. If damaged, have the power tool repaired before use. Many equipment such as dust mask, non-skid safety shoes, hard hat, or hearing accidents are caused by poorly maintained power tools. protection used for appropriate conditions will reduce personal injuries.
Page 5
MINIMUM GAUGE FOR CORD SETS WARNING: ALWAYS wear approved protective safety equipment complying with For Cable length (m): 7.5 the following standards: Use Cable with minimum rating (Amperes) • Eye protection: AS/NZS1337 Eye Protectors for Industrial Applications; Tool Amperes • Hearing protection: AS/NZS1270 Acoustics – Hearing Protection; •...
..direct current ...alternating or direct current FIG. 1 n o ....no load speed ....Class I Construction ....(grounded) .....earthing terminal ....Class II Construction .....safety alert symbol ....(double insulated) RPM ..revolutions per minute …/min ..per minute BPM ..beats per minute sfpm ...
Page 7
3. Release the blade latch (E). Slide the selector (j) to the desired position referring to the table below. The selector can be manipulated during operation. 4. To remove the saw blade, fully retract the blade latch and pull the blade out of the holder.
Proper Hand Position (Fig. 1, 8) 1. Place the dust extraction shroud (N) between the finger guard (F) until it clicks in place. WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand 2. Fit the dust extraction adaptor (M) to the tool as shown. position as shown.
Directives regarding dust tested with this product, use of such accessories with this tool could be hazardous. emission. To reduce the risk of injury, only DeWALT, recommended accessories should be used Sawing in Metal with this product.
Guarantee FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call (AUS) 1800 654 155 or (NZ) 0800 339258 for a free replacement. Applicable to hand held Power Tools, Lasers and Nailers. Three Year Limited Warranty WALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the date of purchase.