Toshiba RAS-B10GKVP-E Service Manual page 104

No. Part name
Fan motor 1) Follow to the procedure in the item
7
2) Loosen the set screw of the cross flow fan.
3) Remove two fixing screws of the motor band
4) Pull the fan motor outward.
Cross flow fan 1) Follow to the procedure in the item
8
2) Remove the heat exchanger fixing holder by
3) Loosen the set screw of the cross flow fan.
4) Lift the left side of the heat exchanger, and
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedures
(Right), and then remove the motor band
(Right).
In assembling work, install the fan motor as
follows.
• When assembling the fan motor, the fan
motor must be installed in such a way that
the fan motor leads will be taken out is
positioned at the bottom front.
• After assembling the two hooking claws of
the motor band (right) into the main body,
position the fan motor, insert it, and then
secure the motor band (right) using the two
fixing screws.
Fan motor leads
removing the two fixing screws used to
secure it.
pull out the cross flow fan.
– 104 –
www.heronhill.co.uk
.
3
Secure using using
the fixing screw g screw
Screw
Motor band (Right) nd (Right)
Screw
Secure using sing
the fixing screw screw
6 .
Remarks
Set screw
Raise the
left side
Pull out here
Fax: 01823 665807