Assemble And Install Storm Collar - Heatilator GNTC50 Owner's Manual

E. Assemble and Install Storm Collar
CAUTION
Sharp Edges!
• Wear protective gloves and safety
glasses during installation.
Connect both halves of the storm collar with two screws (see
Figure 8.16).
Wrap the storm collar around the exposed pipe section and
align brackets. Insert a bolt (provided) through the brackets
and tighten the nut to complete the storm collar assembly.
Make sure the collar is tight against the pipe section. See
Figure 8.17.
Slide the assembled storm collar down the pipe section until
it rests on the roof fl ashing.
Caulk around the top of the storm collar (see Figure 8.15).
34 Heatilator • GNTC50 • 4002-095 Rev H • 06/07
Figure 8.16 Assembling the Storm Collar
Figure 8.17 Assembling the Storm Collar Around the
Pipe