Using Your Zotac Zbox; Configuring Wireless Connection; Configuring Wired Connection; Using A Static Ip - Zotac ZBOX User Manual

Note: If you want to use USB charger for iPhone/iPad, please install the driver
at X:\Utility\Software\Usb Charger\setup.exe (X: your driver disk letter).
Each driver must be installed individually to ensure proper operation of the

ZOTAC ZBOX.
3. Select the driver you want to install. The driver installer should launch.
4. Follow the onscreen instructions to install the drivers.
5. Restart the system.

Using your ZOTAC ZBOX

Configuring wireless connection

To connect to a wireless network, follow the instructions below:
1. Double-click the crossed wireless network icon (pic) on
the notification area.
2. Select the wireless network you want to connect to
from the list and click Connect.
3. After connection was established, you will see
Connected.
For security concerns, Do NOT connect to an

unsecured network, otherwise, the transmitted
information without encryption might be visible to
others.
Enter the network security key if necessary.


Configuring wired connection

Using a static IP

1. Right-click the network icon on the
notification area and select Open
Network Connections.
2. Right-click Local Area Connection and
select Properties.
3. Highlight Internet protocol (TCP/IP) and
click Properties.
4. Select Use the following IP address.
5. Enter your IP address, subnet mask and
Default gateway.
6. If needed, enter the preferred DNS server address.
7. After entering all of the related values, click OK to finish the configuration.
ZOTAC ZBOX
15