Installing the Host Channel Adapter (HCA)
Requirements
Installation Overview
This chapter provides the following information:
•
"Requirements" on page 5
•
"Installation Overview" on page 5
•
"Selecting the Host Connector" on page 6
•
"Selecting the Type of Installation" on page 8
•
HCA cards support 64-bit PCI variants. 32-bit slots are not compatible.
•
A maximum of 3.3V power is required. The HCA(s) should be installed in those slots that are
keyed to provide 3.3V. Note: low-profile HCAs require 1 watt less power.
•
For maximum performance, 133 MHz PCI-X or PCI-Express is required. 100 MHz is the minimum
that can be utilized, but is not recommended.
The following steps are required when performing the HCA installation procedure:
•
"Selecting the Host Connector" on page 6
•
"Selecting the Type of Installation" on page 8
•
"Installing a High Profile HCA in a PCI-X Connector" on page 8
•
"Installing a Low Profile HCA in a PCI-X Connector" on page 9
•
"Installing Two HCAs in One Host with PCI-X Connectors" on page 10
•
"Installing HCA(s) in a 1U Host with PCI-Express Connectors" on page 11
•
"Installing HCA(s) in a 2U+ Host with PCI-Express Connectors" on page 12
5
2