Final Checklist - Fisher & Paykel DishDrawer DD24DA Installation Instructions Manual

TO BE COMPLETED BY THE INSTALLER
Check all parts are installed.
Ensure that all panels and parts thereof are secure and final electrical tests have been
conducted in accordance with local electrical regulations.
Ensure product is level, securely fastened to the cabinetry and opens and closes freely.
The drawers must be free to fully close with no resistance from the cabinetry.
Ensure inlet hose to water supply has supplied rubber washer fitted, and that it's
tightened a further half turn after seal contact.
Ensure any knockouts or plugs in drain connection have been drilled out and drain
connection has been made.
The drain hose joiner must not support the weight of excess hose material. Keep drain
hose as fully extended as possible to prevent sagging. Any excess length of drain hose
should be kept on the dishwasher side of the highloop.
If connecting the drain hose to the sink trap, ensure the Highloop is a minimum 150 mm
higher than the drain hose joiner.
Ensure any packaging or tape securing the racks is removed from the drawers.
Complete and keep for safe reference:
Model
Serial No.
Purchase Date
Purchaser
Dealer Address
Installer's Name
Installer's Signature
Installation Company
Installation Date
!9

FINAL CHECKLIST

Turn on the power
beep and see a program indicator light up on the internal control panel.
Check the spray arms are in place and free to rotate.
Press
up. Close the drawer and press
After the Rinse program has finished, ensure the dishwasher has run and drained
correctly.
Check water supply and drainage connection for leakage.
and water supplies, then open the drawers. You should hear a
on the internal control panel until the indicator of the 'Rinse' program lights
to start the program. Repeat for the other drawer.
Spray arm
19