JVC MX-K50 Service Manual page 17

< Speaker section >
It is exchange in a unit.
Please do not decompose as much as possible.
Removing the front panel
1. Remove the four bosses and duct, and remove the
front panel.
Notes:
It will be good to use the tool with a flat tip, since it is hard
to remove. Please take care not to damage the cabinet at
this time.
Removing the tweeter
Prior to performing the following procedure, remove
the front panel.
1. Remove the cord from the speaker terminal.
2. Remove the two screws A attaching the tweeter on
the front panel (inner side).
Notes:
Squawker cannot be removed.
Removing the woofer
Prior to performing the following procedure, remove
the front panel.
1. Remove the four screws B attaching the woofer and
remove the woofer.
2. Remove the cord from the speaker terminal.
3. Remove the capacitor pasted up on the woofer.
(See Fig. 1 and 2)
Front panel
(See Fig. 2)
Boss
(See Fig. 2 and 3)
Packing
Capacitor
Fig.1
Squawker
Code
A
Duct
Front panel
Fig.2
Speaker terminal
MX-K50
The tool with
a flat tip
Speaker terminal
Tweeter
B
Woofer
Code
Woofer (reverse side)
1-17