Table of Contents
Advertisement
5. MECHANICAL DISASSEMBLY AND REASSEMBLY
This chapter explains the procedures for replacement of parts, assembles and units in the field.
5.1 General
5.1.1 PRECAUTIONS PARTS REPLACEMENT
(1) Before starting disassembly and re-assembly, always turn the AC power switch OFF, and pull
out the AC plug.
(2) Since screws, small parts are likely to be lost, they should temporarily be attached to their
original positions.
(3) When handing items such as circuit boards, do not wear gloves that are likely to generate
static electricity.
(4) Do not place printed circuit boards directly on the equipment or on the floor.
5.1.2 TOOLS
The table shows the tools required for replacement of parts such as circuit boards and
mechanical units.
ITEM
1
2
3
4
5
6
7
8
9
SERVICE TOOLS
PHILIPS SCREWDRIVER (L)
PHILIPS SCREWDRIVER (M)
PHILIPS SCREWDRIVER (S)
STRAIGHT SCREWDRIVER
RADIO PLIERS
CUTTING PLIERS
MULTIMETER
DIGITAL STORAGE
OSCILLOSCOPE 100MHZ(UP)
OFFSET TYPE SCREWDRIVER
TYPE
RUBICON 107
RUBICON 102
RUBICON 104
RUBICON 101
4"
NO.2
5-1
Q'TY
REMARKS
1
M3 SCREW
1
M2.6 SCREW
1
M2.3 SCREW
1
E RING
1
1
1
SHORT-
CIRCUIT TEST
1
1
Advertisement
Table of Contents
