Table of Contents
Advertisement
Quick Links
Bagless Upright
WARNING: This cleaner has a constantly
rotating brush bar which, when left in contact
with lino, parquet and other hard flooring could
potentially cause some damage to the floor surface.
NOTE: Vax recommends that you raise the height of
the brush bar when using this cleaner on lino and hard
flooring. Vax cannot be held responsible for damage
to these surfaces if the customer fails to take notice of
this recommendation.
Get Cleaning...
What's your Vax's model number?
V
P
U
P
2
0
What's your serial number?
-
Note these down in case you need them in future. Please keep instructions for further use.
www.vax.com.au
Vax Service line AU: 1300 361 505
pet
0
0
P
(Located on the base of the machine)
-
-
User Guide
NZ: 0800 800 900
-
-
VPUP2000P
Advertisement
Table of Contents
Related Manuals for Vax VPUP2000P
Summary of Contents for Vax VPUP2000P
- Page 1 NOTE: Vax recommends that you raise the height of the brush bar when using this cleaner on lino and hard flooring. Vax cannot be held responsible for damage to these surfaces if the customer fails to take notice of this recommendation.
-
Page 2: Machine Overview
Power on/off Filter the height of the brush bar when using Handle release Dirt container this cleaner on lino and hard flooring. Vax Wheels Carpet height adjuster cannot be held responsible for damage to Brush bar and brush these surfaces if the customer fails to take bar windows notice of this recommendation. -
Page 3: General Safety Information
Before plugging the cord into the electrical outlet, make sure the switch is in the ‘off’ position. Hold the vacuum 6. Use only as described in this manual. Use only Vax cleaner firmly when starting and in use. recommended attachments. -
Page 4: Operation
2. Slide the end of the lower hose onto the side connector. 6. Clip the TurboTool onto the front of the TurboTool caddy. 3. Place the upper handle onto the upright back panel. Vax Service line AU: 1300 361 505 / NZ: 0800 800 900... - Page 5 Insert the tab on the bottom of the dirt container into the rectangular slot on the cleaner. To secure the dirt container, push the top in place. There will be an audible click when it is secure. www.vax.com.au...
-
Page 6: Cord Release
IMPORTANT: This vacuum cleaner is not the floor. Vax recommend that the brushbar height adjust is intended for use on hard floors. The powerful turned to its highest position when using the tools. -
Page 7: Carry Handle
NOTE: Check that the dirt container is securely in place crevice tool. Pull the crevice tool out of the extension tube or before lifting the vacuum cleaner. hose handle. To remove the tool, twist and pull apart gently. NOTE: The crevice tool is stored inside the extension tube. www.vax.com.au... -
Page 8: Maintenance
(inset). Push to click 2. Hold the dirt container and grasp the top of the filter. into place. Twist and pull the filter up and out. Empty the dirt container completely. Vax Service line AU: 1300 361 505 / NZ: 0800 800 900... -
Page 9: Clearing Blockages
Twist and pull the filter up and out. Empty the dirt container completely. Check to see if dirt container is full. Empty and clean the dirt container filter. Unwrap the hose from the caddy. Remove any obstruction if visible in the end of the hose. www.vax.com.au... -
Page 10: Turbo Tool
Slip the O-ring into the groove at the neck of the Turbo Tool to complete re-assembly. ‘O’ Ring Pivot lowering housing and remove clog. ‘O’ Ring Vax Service line AU: 1300 361 505 / NZ: 0800 800 900... - Page 11 1. Check attachment. Air flow restricted with attachment use 2. New carpet debris clogging air path. 2. Remove obstruction. Don’t take your machine back to the shop, simply contact us AU: 1300 361 505 www.vax.com.au NZ: 0800 800 900 www.vax.com.au...
-
Page 12: Other Information
Monday - Friday 8.30am to 5.30pm Any queries or concerns about using the Vax, call the Vax Careline. Calls are charged at the Standard national rate. Please make a note of the serial number and model number of the carpet cleaner before calling. - Page 13 Notes www.vax.com.au...
- Page 14 Notes Vax Service line AU: 1300 361 505 / NZ: 0800 800 900...
- Page 15 Notes www.vax.com.au...
- Page 16 Distributed by Techtronic Industries Ptd. Ltd. Level 1. 666 Doncaster Rd, Doncaster, Australia 3108. www.vax.com.au Service Line: AU: 1300 361 505 / NZ: 0800 800 900...