11
DISASSEMBLY PROCEDURES
11.1
Fresh Food Compartment
11.1.1
Light Switch
Use a taped putty knife to carefully pry the light switch out of the liner. When the light switch is free
of the compartment liner, remove the wires from the light switch. Remove the light switch from the
unit.
11.1.2
Electronic Control (Full Electronic Specification Model (RX256DT7X1))
1.
Remove the hex head screws holding the control to the cabinet.
2.
Unplug the connectors from the cabinet harness and remove the control assembly.
3.
Remove the cover of the board by squeezing the tabs on the cover to release the cover from the
assembly to expose the electronic control.
4.
Unplug the wires from the electronic control board and unclip it from the control assembly.
Full Electronic Specification Control Panel (RX256DT7X1)
11.1.3
Ice And Water Dispenser Board
1.
Remove the drip tray by pulling it straight out from the door.
2.
Remove the two hex screws at the bottom of the façade that were hidden by the drip tray.
3.
Push down on the façade to release the retainer clips.
4.
Remove the façade and disconnect the ten-pin connector from the dispenser board.
5.
Reverse the procedure to reassemble.
Full Electronic Specification Control (RX256DT7X1)
75
321023