Table of Contents
Advertisement
Main body assembling
Connect the engine (A) to
the tube (B) with four screws
(C).
Assembling the handlebars
• Slide on the throttle
handle on the right-hand
side of the handlebars,
(see the diagram).
• Align the hole in the
throttle handle for the
fixing screw with the
hole at the handlebars.
• Refit the screw in the
rear of the throttle
handle.
• Fit the screw through the
throttle handle and the
handlebars and tighten.
• Fit the handle bar in the
handle bar clamp on the
shaft with six screws.
• Attach the cabling to the
shaft with two cabling
holders.
• Put on the harness and
hang the machine in the
suspension hook. Now
finely adjust so that the
machine gives a
comfortable working
position when it's
attached to the harness.
Tighten the handle.
ASSEMBLY
C
B
C
A
142R
Assembly of the blade and trimmer
head
It is extremely important
that the disc drive's/support
flange's guide engages
correctly in the cutting
equipment's centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.
!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter "Technical
data" . If the wrong guard or a defective
guard is fitted this can cause serious
personal injury.
IMPORTANT INFORMATION
The machine must be equipped with the correct
handlebars, blade guard and harness if either a
clearing blade or grass blade are to be used.
Assembling the transport guard
1) Insert the tips of the
blade into the grooves
in the transport guard
(A).
2) Wind the guard
around the blade, then
snap the hook (B) to
secure the transport
guard.
A
B
17
English –
Hide quick links:
Advertisement
Table of Contents
