Table of Contents
Advertisement
Chapter
03
Before you start
On first-time startup
When you use the navigation system for the
first time, an initial setup process starts auto-
matically. Follow the steps below.
1
Start the engine to boot up the system.
2
Wait approximately 10 seconds, and
then press the MODE button of the AV re-
ceiver.
After a short pause, the navigation splash
screen appears.
3
Set the video output selector switch ac-
cording to your AV receiver.
p If the screen remains black after pressing
the MODE button of the AV receiver, set the
switch to the other side.
= For details, refer to Checking part names
and functions.
4
Select the language that you want to
use on the screen, then touch [Done].
p Later you can change it in "Regional" set-
tings.
= For details, refer to Customizing the regional
settings.
The navigation system will restart and the
"End User Licence Agreement" screen is dis-
played.
5
Read the terms carefully, checking its
details, and then touch [Accept] if you
agree to the conditions.
The configuration wizard starts.
6
Touch [Next] to continue.
7
Select the language that you want to
use for voice guidance messages, then
touch [Next].
p Later you can change it in "Sound and
Warnings" settings.
= For details, refer to Setting the volume and
the guidance voice for navigation system.
8
If needed, modify the time format and
unit settings, then touch [Next].
p Later you can change it in "Regional" set-
tings.
= For details, refer to Customizing the regional
settings.
Advertisement
Table of Contents
