Extron electronics SW2 VGArs User Manual page 4

im Vertrieb von
www.camboard.de
CAMBOARD Electronics
Quick Start Guide — SW VGArs / Ars Series
Install and operate the SW VGArs / Ars Series switchers as follows:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
Mount the switcher in a rack or furniture, or place it on a desktop.
Step 3
Connect up to six video input cables,
depending on the switcher model.
(Ars models only) Connect up to six audio
input cables, depending on the switcher
model.
Step 4
Connect the video output cable.
Step 5
(Ars models
only) Cable the
audio output
connector for
stereo or mono,
balanced or
unbalanced
audio output.
Step 6
Connect an RS-232 OR a contact closure
controller. Wire the connector as shown
in the table at right.
Step 7
Connect power cords and turn on the
equipment in the following order:
output devices (such as projectors,
monitors, and/or speakers), SW VGArs
Series switcher, contact closure/RS-232
controller, and input devices (such as
computers and/or audio sources).
Tel. 07131 911201
Fax 07131 911203
Tip CAUTION
See caution
Sleeve
Tip
See caution
Unbalanced Output
Tip
Ring
Sleeve (s)
Tip
Ring
Balanced Output
ce-info@camboard.de
SW VGArs / Ars Series Switchers • Quick Start Guide
Video Input Audio Input
Connector Connector
1
OUTPUT
Connect the sleeve
to ground.
Connecting the
sleeve to a negative
(-) terminal will
damage the audio
output circuits.
REMOTE
Contact
RS-232 Closure Function
PIN
— In #1 Input #1
1
TX — Transmit data
2
RX — Receive data
3
4 — In #2 Input #2
Gnd Gnd Ground
5
— In #3 Input #3
6
— In #4 Input #4
7
— In #5 Input #5
8
— In #6 Input #6
9
QS-1