Attaching Accessories - Morphy Richards 70455 Instructions Manual

70455 Rev 1 13/9/07

Attaching accessories

WARNING: Always switch the unit off
and wait for the steam to disperse before
attaching and detaching accessories.
WARNING: Never direct steam at
electrical components/fittings. If in doubt
about the suitability of steam for
cleaning an appliance, contact the
appliance manufacturer for advice prior
to cleaning.
IMPORTANT: It is strongly recommended
that after fitting the new attachment, the
hose end is held over the sink initially as a
small amount of hot water may be ejected
before the steam reaches full pressure.
1 Jet nozzle
Attach the jet nozzle Ê to the hose end
fi by lining up the lugs and twisting to
lock in place E.
The jet nozzle is ideal for:
• General cleaning tasks, for work
surfaces, tile grouting and for awkward
corners and spaces.
• Defrosting freezers and removing dust
from plants.
The closer you hold the jet nozzle to the
surface to be cleaned, the better the
cleaning results.
E
F
14:43 Page 5
The following accessories can be added
onto the jet nozzle by simply pushing to fit:
2 Directional nozzle
Push the directional nozzle onto the jet
nozzle F.
The directional nozzle Á is ideal for
getting steam into awkward spaces and for
directing steam under the lip of sink/toilet
bowls, grout, tap ware, venetian blinds, and
sliding door runners.
3 The round brush
Push the round brush onto the jet nozzle
G.
The round brush  is ideal for hob
cleaning and tile grouting depending on the
application.
4 Upholstery nozzle
Alternatively, the upholstery nozzle È
can be attached to the hose end fi H.
• This can be used for cleaning upholstery
or removing creases from clothing.
• Place garments onto a clothes hanger
and spray steam at a distance of around
10-20cm.
G
H
5