Table of Contents
Advertisement
Location of Controls
RADIO POWER
LIGHT
ENTER/SELECT TUNE MODE
BAND/SET
FM S ENS
FM a n te n n a
DX/LOCAL
* Th e re is a ta c tile d o t b e s id e VOL to s h o w th e d ire c tio n to tu rn u p
th e vo lu m e .
SECTION 2
GENERAL
FREEZE
P RESET
MHz
FM
kHz
MPH
AM
km/h inch
m m
AM
MPH
km /h
PM
m ile
CLOCK ODO DIST RT AVG MAX
J o g le ve r
VOL*
Setting the Clock
The clock time display of this unit is a 12-hour system.
When the batteries are first installed, AM 12:00 flashes and CLOCK turns on
in the display.
1
Press RADIO POWER to turn off the power.
2
Press MODE/FREEZE repeatedly until CLOCK appears.
3
Hold down ENTER/SELECT for more than 2 seconds until
AM 12 starts flashing.
4
Push the Jog lever towards + or – to adjust the hour, then press
ENTER/SELECT.
The beep sounds and the minute setting starts to flash.
If you hold down the Jog lever towards + or —, the digit changes rapidly.
Midnight is indicated as AM 12:00 and Noon is indicated by PM 12:00.
5
Repeat step 4 above to adjust the minutes.
: starts flashing and the clock starts operating.
To set the current time exactly to the second, adjust the minute setting and
then press ENTER/S ELECT to synchronize it with a time signal (such as
the telephone time signal).
No te
If you do not push the Jog lever towards + or —, or ENTER/S ELECT within
about 65 seconds, the clock setting mode will be canceled.
ICF-M88B
This section is extracted from
instruction manual.
3
Advertisement
Table of Contents
