Table of Contents
Advertisement
Working with Media
Installing a New Roll into the Printer
4 Place the spindle vertically on the floor, with the media stop at the bottom. Remove
5 Alternatively if the media roll is very long, rest it horizontally on a table and load
6 Push the end cap in, making sure that the tabs are flush against the ends of the roll.
3-34
the end cap from the top of the spindle, and slide the new roll onto the spindle. The
leading edge of the media must wind clockwise as shown below.
the media on the table.
Correct
If the media stop falls off, push it back in until it snaps into position.
Push it far enough to be firm, but do not use excessive force as this may result in
broken tabs.
Incorrect
B
A
B
C4723120
B
C4723119
A
The endcap has a
tendency to come apart
in two pieces, just fit it
back together if this
happens.
Once the endcap is
pushed partway into the
roll, push the center
piece of the endcap in
first and then the outer
piece.
Advertisement
Table of Contents
