Table of Contents
Advertisement
Working with Media
Removing a Roll from the Printer
5 Remove the old roll by pulling firmly on each end of the spindle, A then B.
6 Rest the old roll upright on the floor so that the media stop (A) is on top. Pull out the
7 You have completed removing the old roll media from the printer. If you are not
3-32
media stop A and the spindle. Pull out the endcap (B) from the other end of the old
roll.
A
NOTE:Alternatively if the media roll is very long, rest it horizontally on a table and
unload the media on the table.
immediately loading another roll of media into the printer, replace the endcap on the
spindle and place the spindle back in the printer.
To load a new roll of media, continue with the next section, Installing a New Roll
into the Printer.
B
C4723125
A
C4723121
B
C4723126
Advertisement
Table of Contents
