FujiFilm FinePix A900 Owner's Manual page 126

Warning Displays
Warning Displayed
CARD ERROR
\ MEMORY FULL
Y MEMORY FULL
WRITE ERROR
PROTECTED CARD
INTERNAL MEMORY IS
FULL
INSERT A NEW CARD
BUSY
FRAME NO. FULL
126
Explanation
• The Memory Card contact area is soiled.
• The Memory Card format is incorrect.
• Camera fault.
• The Memory Card is damaged.
• Inserted Memory Card is not compatible with your
camera.
The internal memory or Memory Card is full.
• The data could not be recorded due to a Memory
Card error or a connection error between the
Memory Card and camera.
• The image cannot be recorded as it is too large to
fit in the available space on the Memory Card.
• The Memory Card or internal memory is not
formatted.
The SD Memory Card switch is slide to the "Lock"
side.
The data could not be recorded or copied since the
internal memory is full.
The timing for recording was incorrect because the
Memory Card was formatted on a PC.
The frame number has reached 999-9999.
Remedy
• Wipe the contact area on the Memory Card with a
soft, dry cloth. It may be necessary to format the
Memory Card (➝p.93). If the message still
appears, replace the Memory Card.
• Contact your FUJIFILM dealer.
• Insert a compatible Memory Card that is operation-
checked at FUJIFILM Corporation (➝p.19).
Erase some images in internal memory or Memory
Card (➝p.38), or use a Memory Card that has ample
free space.
• Re-insert the Memory Card or turn the camera off
and then on again. If the message still appears,
contact your FUJIFILM dealer.
• Use a new Memory Card.
• Format the Memory Card or internal memory on
the camera (➝p.93).
Unlock the protection by sliding it back (➝p.20).
Erase some images from the internal memory
(➝p.38), or use a Memory Card that has ample free
space.
Use a Memory Card that was formatted on the
camera.
A Insert a formatted Memory Card into the camera.
B Set RENEW as the FRAME NO. setting in the
SET-UP menu (➝p.90).
C Start taking pictures (The frame number starts
from "100-0001").
D Set CONT. as the FRAME NO. setting in the
SET-UP menu.