Servicing Notes - Sony NW-S4 Service Manual

1-1. Introduction
This document describes the "operation check for inspection (Test mode)" and "adjustment after board replacement for repair".
In performing these works, connect this set to the PC via a USB cable and use the following tool.
Tool list
Ref. No. Tool name
1
1-2. Board Repair
1. In performing the work, the set should be in a complete state (all components assembled).
2. Install the "OpenMG Jukebox" and "WMP7 Plug-in" (CD-ROM) in the PC in advance.
3. Do not start up other applications in the PC.
4. This set has the Test mode, and various functions can be checked by using exclusive application (Service Tool) on the PC side.
5. Be sure to replace the MAIN board, if any part listed in Table 1-1 is faulty.
6. The data in Table 1-2 have been written to the MAIN board.
7. In repairing other than above parts, repair as usual.
Table 1-1.
Board name
MAIN board IC601, IC602, IC603, IC901
Table 1-2.
Board name
MAIN board Music data, Equalizer initial values, CODEC programs, and ID/IK codes
1-3. Operation Check for Inspection (Test Mode)
Precautions
1. Be sure to remove the battery from this set. (The power is supplied via USB cable)
Operating the set in the Test mode with the battery loaded could clear necessary information.
2. If operation check was performed for inspection, execute "Play Info Initialize" in qd (see page 7) to return respective functions to
initial positions (see Table 1-5 on page 7). In such a case, record current position of each function before executing "Play Info
Initialize" in qd, if necessary.
SECTION 1

SERVICING NOTES

Part code
Ref. No
Stored data
Application
Board check (Test mode) and readjustment after board replacement
NW-S4
3