Maintenance And Service - Infinity Modulus MS-1 Owner's Manual

C
ONNECTIONS
Turn Off All Power
After placing the speakers, you are ready to connect your
system. First, turn off all audio-system power. Use high-quality
speaker wire to make your connections. Use at least #16-gauge
speaker wire with polarity coding.The side of the wire with
a ridge or other coding is usually considered positive polarity
(i.e., + ). Also, consult the owner's manuals that were included
with your amplifier or receiver to confirm connection
procedures.
Important!
Do not reverse polarities (i.e., + to – or – to +) when making
connections. Doing so will cause poor imaging and diminished
bass response. Be certain that positive and negative wire
strands are completely isolated to avoid short circuits that may
damage your equipment.
F 10
IGURE – Wiring diagram shows polarity connections for one
channel of a stereo or home theater system.
MODULUS MS-1
6
M
AINTENANCE AND
The speaker enclosures may be cleaned using a soft cloth,
dampened with water only, to remove fingerprints or to wipe
off dust.
The grilles may be gently vacuumed. Do not use any solvents on
the grille.
All wiring connections should be inspected and cleaned or
remade periodically.The frequency of maintenance depends on
the metals involved in the connections, atmospheric conditions,
and other factors, but once per year is the minimum.
If a problem occurs, make sure that all connections are properly
made and clean. If a problem exists in one loudspeaker, reverse
the connection wires to the left and right system. If the problem
remains in the same speaker, then the fault is with the loud-
speaker. If the problem appears in the opposite speaker, the
cause is in another component or cable. In the event that your
Modulus loudspeakers ever need service, contact your local
Infinity dealer or Infinity directly at 1-800-553-3332 or
www.infinitysystems.com for a service center near you.
S
ERVICE