Advertisement
ii
I
(10) The pulley (big) and holder can be dismounted by removing the pulley (big) fitting ring. (Fig. 4)
(11 ) Removing the fitting screw on the eafih read wire 65L of the chassis side. Removing the two lead
wires 155L, the earth lead wire 65L and two Ceramic Capacitor, fixed on the terminal. By removing
the terminal fitting screw, the terminal and the sheet can be dismounted.
(12) The power cord can be taked off by removing the cord bushing from chassis.
(13) The inner cabinet ass'y can be removed by removing the 3 fitting screws of the holder (base) ass'y,
and setting tab of the shield to its horizontal position. (Fig. 3)
4)
(14) The shield can be removed by removing the 2 fitting screws of the shield.
(15) Pull out the 2 sockets of the lead wire from the heater. By removing the heater supporting insulator
(16)
(17)
(18)
fitting nut and the insulator A fitting hook@ of inner cabinet (M), the heater ass'y and insulator A
can be dismounted from the inner cabinet. (Fig. 5)
By removing the fitting screw of the holder (heater), the holder (heater) and the insulator can be
dismounted from heater ass'y. (Fig. 5)
The fuse unit can be dismounted by removing the screw inside of the inner cabinet which is fixing
the fuse unit. The fuse ass'y can be removed by straightening the fixing tab of the holder (fuse).
(Fig. 5)
The sensor ass'y and the holder (sensor) can be dismounted by removing the screw inside of the
-
inner cabinet which is fixing the sensor ass'y. (Fig. 5)
Insluator A
\
(Fig. 5)
17
Advertisement
