Advertisement
i
7. Disassembly
Procedures
1.
Disassembly
of lid
(1)
The lid ass'y can be dismounted while the lid open and pulling upward.
(2) The window, holder (window) and air window can be dismounted by removing tab of lid fixing frame.
(Fig. 1)
2. Disassembly
of main unit
/
(1)
The bottom lid can be dismounted by removing 4 fitting screws and 4 stands on the bottom lid.
(2) Removing the fitting screw on the rear and left side of control panel.
The control panel can be
removed from the main unit by removing tab of control panel out of cabinet, through pressing
rightward on the rear surface of control panel.
The control panel can be dismounted by removing
detached 2 sockets from the control PCB ass'y.
(3) The control PCB ass'y can be removed from control panel by removing the 3 fitting screws and tab
of control panel.
(4) Removing
the 3 fitting screws of the terminal.
And removing
the power cord ass'y can be
dismounted from the main unit by loosen the fasten screw of the cord bushing.
(5) The main unit can be pulled up after removing 6 fitting screws of inner cabinet (U), and the main unit
and hinge can be separated
out of cabinet. (Fig. 2) The cord bushing can be dismounted
by
removing the net of the cord bushing from the cabinet.
(6) Cut the 3 fixers that hold the lead wire. Then, remove the following sockets: socket from the motor,
socket from the heater, socket from the fuse ass'y, connector from the motor and connector from the
two lead wires.
(7) The power PCB ass'y can be dismounted by removing the fitting screw of power PCB ass'y and
fitting screw of support. (Fig. 3)
(8) The capacitor can be dismounted by removing the fitting screw. (Fig. 3)
(9) By removing the 3 motor fitting screws,
Self-tap ing screw,
J'
Tappin screw
truss h .4x 8mm
i
trussh
.4x Ilmm
v
'Figo2)
the motor ass'y and belt can be removed from frame, (Fig. 3)
b
Screw,pan spring
washer4
x
6mm
(Fig.
3)
,
16
Advertisement
