Mitsubishi Electric WD-52525 Part Replacement Instructions page 6

MITSUBISHI INSTRUCTIONS: V26 CHASSIS REPLACEMENT
NOTE: To remove the chassis, the two connectors to the Lamp Ballast must be
disconnected at the Lamp Ballast.
Accessing & Disconnecting The Lamp Ballast
Removing the Right Support
1) Remove the 3 screws shown below.
Removing the Lamp Ballast Shield
(4 screws)
4 Screws
Chassis can now be removed.
NEW CHASSIS INSTALLATION
To install a new chassis, reverse previous steps for removal.
Perform DATA COPY Procedure: MENU+24570, select "Copy Light Engine Data to DM", press ENTER.
See V26 Service Manual for Details.
3 Screws
Curved
Air Duct
Mitsubishi Digital Electronics America, Inc
Unplug CN1 & CN2
Connectors
Unplug
Connectors
Page 4