Table of Contents
Advertisement
Rotating the Machine Head
❏ Before any work on the machine itself,
pull the mains plug.
Completely unscrew the four screws. Rotate the
machine head carefully, without removing it
from the housing, to the new position. Screw in
and tighten the four screws again.
Starting Operation
❏ Observe correct mains voltage! The volt-
age of the power source must agree with
the voltage specified on the nameplate of
the machine. Power tools marked with
230 V can also be operated with 220 V.
When operating the machine with power from
mobile generators that do not have sufficient reserve
capacity or are not equipped with suitable voltage
control with starting current amplification, loss of
performance or untypical behavior can occur upon
switching on.
Please observe the suitability of the power generator
being used.
Switching On and Off
To start the power tool, push the On/Off switch 4
forwards.
To lock the On/Off switch 4, press the On/Off
switch 4 down at the front until it latches.
To switch off the power tool, release the On/Off
switch 4 or, if it is locked, briefly push down the back
of the On/Off switch 4 and then release it.
❏ Check grinding tools before using. The
grinding tool must be mounted properly
and be able to move freely. Carry out a
test run for at least one minute with no
load. Do not use damaged, out-of-centre
or vibrating grinding tools. Damaged grind-
ing tools can burst and cause injuries.
1 609 929 L48 • 15.6.07
The machine head
can be rotated with
respect
to
the
machine housing in
90°
steps.
In
this
manner, the On/Off
switch can be brought
into a more conven-
ient position for spe-
cial
working
situations,
e.g.
for
left-handed persons.
Kickback stop (EWS 125-S/
EWS 125-ES/ EWS 14-125 S/
EWS 14-150 S)
In case of a sudden drop in speed, e. g. jamming
while carrying out a separating cut, the power supply
to the motor is interrupted.
To restart the operation, switch the On/Off
switch 4 to the Off position and start the machine
again.
Restarting protection (EWS 125-S/
EWS 125-ES/ EWS 14-125 S/
EWS 14-150 S)
The restarting protection feature prevents uncon-
trolled restarting of the machine after an interruption
in the power supply.
To restart the operation, switch the On/Off
switch 4 to the Off position and start the machine
again.
Reduced starting current
(EWS 125-S/EWS 125-ES/
EWS 14-125 S/EWS 14-150 S)
The electronic reduced starting current limits the
power consumption when switching the tool on and
enables operation from a 13 ampere fuse.
Constant Electronic Control
(EWS 125-S/EWS 125-ES/
EWS 14-125 S/EWS 14-150 S)
Constant electronic control holds the speed constant
at no-load and under load, and ensures uniform
working performance.
English–21
Advertisement
Table of Contents
