Fujitsu CREMSON MODULAR STARTERKIT User Manual page 15

Cremson Modular Starterkit
Chapter 3 Getting Started
If these settings are correct, start your debugging session :
First please make sure you are using the F369 CPU-board and your monitor-kernel is stored
in the flash memory of the MB91F369. Then please power up and reset the starterkit.
Start the debugger by double clicking the "MonDeb 57k6 COM1" entry in the project/debug
tree - or by using "Debug – Start Debug" from the menu. You should see a progress bar
indicating the download process.
If nothing happens, there will be an error message after some time ("Invalid communication
status"). Double-check the settings again as explained above. Also make sure the
evaluation-board is powered on, ready to use and the RS232-cable is connected properly.
Also see the trouble-shooting section in the appendix.
After starting the debugger, additional windows will appear which contain
locate-arrows for each (possible) source-line, the original source-code,
Figure 2: SWB Debugging window
breakpoint-indicators and the assembler code (in "mixed view"). The actual program position
will be indicated by a yellow line.
You can choose "mixed view" from the context menu (right-click) to display source
and assembly code at the same time. To easily locate the actual line, use "go to current" !
© Fujitsu Microelectronics Europe GmbH - 15 -