Troy-Bilt 24B-060F766 Operator's Manual page 10

4
Operating
Your Yard
Vacuum
WARNING
Do not at any time
make any adjustments
without first stopping
engine and disconnect-
ing spark plug wire.
�
�
Figure 9
����� ����
Figure 10
�
Figure 11
To Empty Bag
1. a. Unhook bag straps from the lower handle.
b. Unsnap bag clip from the top of lower handle. See
c. Grasp bag handle with one hand and pull lock rod
d. Lift bag off back of unit.
2. Twist the two buttons on the back of the bag to unlock
�
and empty contents. See Figure 10. Hold bag handle
and bag clip while emptying the contents.
3. Compress bag opening and fold inner flap over
opening.
4. Fold outer flap over inner flap and insert buttons on
the bag through metal outlets. See Figure 10.
5. Twist the buttons to lock bag. Place bag back onto unit
as instructed on page 7.
�
Using The Nozzle Vacuum
Yard waste such as leaves and pine needles can be
vacuumed up through the nozzle for shredding. After
material has been shredded by the flail blades on the
impeller assembly, it will be discharged into catcher bag.
Do not attempt to shred or chip any material other than
vegetation found in a normal yard (i.e. branches, leaves,
twigs, etc.) Avoid fibrous plants such as tomato vines until
they are thoroughly dried out. Materials such as stalks or
heavy branches up to 1 1/2" in diameter may be fed into
the chipper chute.
�������
1. Place nozzle/hose vac lever in the top position on the
nozzle to vacuum through nozzle. See Figure 11.
2. The spring loaded pin must be in the first hole (closest
�����
to the end of the tube) of the hose adapter to operate
����
the nozzle vac. See Figure 11.
3. Place both hands on top of upper handle to push unit
over yard waste.
�
10
Figure 9.
on mounting bracket with other hand toward engine
to release.