Kenwood KDC-319/4019 Service Manual page 8

KDC-319/4019,5020
3. When the message "Security" is displayed, press and
hold the Track Up/Down key for 1 second to enter the
security registration mode.
4. Enter the code using the FM/AM/Track Up/Track
Down keys.
• FM key
• Am key
• Track Up key
• Track Down key : Cursor left shift
5. Hold down the Track Up key for at least 3 seconds
and the message, "RE-ENTER" appears, so once
again enter the code according to Step 4 above.
6. Press and hold the Track Up key for 3 seconds until
"APPROVED" is displayed.
7. Exit from the test mode. (See 2. How to exit from the
test mode)
(Note) All Clear is not applicable to the security code
of this model.
8
TEST MODE
: Number up
: Number down
: Cursor right shift
3. Simplified method of clearing the security code
(K Type only)
1. While the code entry is requested, press and hold the
VOL UP key for 3 seconds while holding the DISP key
pressed. (This should turn "----" off.)
2. Enter "KCAR" from the remote. (Same way as the 01
model)
• Press the 5 key on the remote twice, then press the
Track Up key. (This enters "K".)
• Press the 2 key on the remote 3 times, then press
the Track Up key. (This enters "C".)
• Press the 2 key on the remote once, then press the
Track Up key. (This enters "A".)
• Press the 7 key on the remote twice, then press the
Track Up key. (This enters "R".)
3. The security code is cleared and the unit enters the
ALL OFF mode.
4. If you commit a mistake in the code entry, the unit
enters the code request mode again.