D-Link DI-304 User Manual page 76

♦
Dial ISDN – Clicking here causes the router to dial to the preset ISP.
Click Internet Access Setup → Dial to a Single ISP to configure dial-up
settings.
♦
Activity – Displays the connection name for each B channel. If the B
channel is idle, it will show Idle.
◊ Drop B1 - Click to disconnect the B1 channel.
◊ Drop B2 - Click to disconnect the B2 channel.
Broadband Access
♦
Broadband Access Mode/Status – Displays the broadband access mode
and status. If the broadband connection is active, it will show PPPoE,
PPTP, or Static IP depending on which access mode is enabled. If the
connection is idle, it will show "- - -".
♦
WAN IP Address – The WAN IP address for the active connection.
♦
Dial PPPoE or PPTP – Click to force the router to establish a PPPoE or
PPTP connection.
♦
Drop PPPoE or PPTP – Click to force the router to disconnect the
current active PPPoE or PPTP connection.
Triggered Dial-out Packet Header
Triggered Dial-out Packet Header shows the last IP packet header that triggers the
router to dial out.
♦
Refresh – Click to reload the page.
View Routing Table:
Click View Routing Table to view the router's routing table.