Mitsubishi MJ-E14CG-S1-IT Instruction Manual page 24

Maintenance (Cont.)
Air filter
1
Remove the front panel and
pre-filter.
1 Remove by holding
the bottom.
Performance is
unaffected even if the
metal fins inside the main
unit are slightly bent.
2
Remove the air filter.
3
Soak the air filter in water.
Do not use detergent or hot water.
Also, do not brush or rub while
soaking as this may damage the filter.
• Stains may remain on the filter, but should not
affect performance.
• The filter can be soaked for a total of eight
times.
After that, replace with a new filter.
4
e_mj_e14cg_s1_it.indb 24
Once every three months
Soak the filter in water about once every three months.
For maintenance procedures see
Front panel
Pre-filter
2 Remove by
holding the
tabs.
Air filter
Pre-filter
Soak in cool to
lukewarm water for 30
minutes.
10
4
Dry the air filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
5
Fit the air filter.
With the strips facing up, set the air
filter inside the tabs on the pre-filter.
Tabs (6)
6
Attach the pre-filter and front
panel.
1 Attach by holding
the tabs.
2 Hook the top edge
to the top part of
the unit and push
the bottom in.
2013/06/22 19:37:14