Network Setting; Ethernet Network Connection; Wireless Network Connection; Add Network - Sharp LC-60UF30H Operation Manual

Network function

Network setting

Select "Menu" in the smart home, and then press
ENTER. Press a/b to select "Network", and then
press ENTER . It displays the connect format.

Ethernet network connection

Press a/b to select "Ethernet network
1
connection", and then press ENTER.
Press c/d to adjust "Ethernet" to "On".
2
w DHCP
Press a/b to select "DHCP". Press c/d to select
"On". System will attempt to obtain IP address and
other information automatically.
w Manual connection
Press a/b to select "DHCP". Press c/d to select
"Off ". You can setup IP address, Gateway, Subnet
mask, First DNS and Second DNS following the on-
screen instructions. After setting, press a/b to select
"Save", and now you can enjoy the internet services.

Wireless network connection

Press a/b to select "Wireless network
1
connection", and then press ENTER.
Press c/d to adjust "Wi-Fi" to "On", it
2
displays the nearly wireless network.
Press a/b to select an available wireless
3
network , and then press ENTER. If the
current network connection security is not
open, you should enter the password from
software keyboard by pressing ENTER on
the remote control. If the network connection
security is open, you can connect it directly.
Select "Refresh", and then press ENTER, it
displays the "Wireless network list".
NOTE
• You can press MENU to select "Network" to switch the
connection between Ethernet network connection and
Wireless network connection.
26

Add network

Select "Add network" , and then press
1
ENTER. You can add unbroadcast wireless
network manually.
Enter the information about the unbroadcast
2
wireless network , and then select "Save". Now
the TV is connected to the unbroadcasted
wireless network.