Table of Contents
Advertisement
CARE AND MAINTENANCE
Your Titan 1000 XD Metal Detector is an example of superior design and crafts-
manship. The following suggestions will help you care for your metal detector so
you can enjoy it for years to come.
Keep the detector's chassis dry and do not let water enter it. If the chassis gets
wet, wipe it dry immediately. Liquids might contain minerals that can corrode the
electronic circuits.
Use and store the detector only in normal temperature
environments. Temperature extremes can shorten the
life of electronic devices, damage batteries, and distort
or melt plastic parts.
Keep the detector away from dust and dirt, which can
cause premature wear of parts.
Handle the detector gently and carefully. Dropping it
can damage circuit boards and cases and can cause the
detector to work improperly.
Use only fresh batteries of the required size and type. Old
batteries can leak chemicals that damage your detector's
electronic parts.
Wipe the detector with a damp cloth occasionally to keep
it looking new. Do not use harsh chemicals, cleaning
solvents, or strong detergents to clean it.
Modify or tampering with the detector's internal
components can cause a malfunction and might invalidate
it's warranty.
The searchcoil supplied with the detector is waterproof however, and may be
submerged in either fresh or salt water. After using the searchcoil in salt water,
rinse it with fresh water to prevent corrosion of the metal parts.
18
ASSEMBLY
Assembly is easy and requires no tools.
1
Position the lower stem (the straight tube)
with the silver button toward the back.
Using the bolt and knurled knob,
attach the search coil to the plastic
extension protruding from the
lower stem.
2
Press the button
on the upper end
of the lower stem,
and
slide
the
lower stem into
the upper stem.
Adjust the stem to a length
that lets you maintain a
comfortable upright posture,
with your arm relaxed at
your side, and the search
coil parallel to the ground in
front of you.
3
Wind the cable securely around the stem.
4
Insert the plug into the
matching connector on
the right underside of the
detector body.
Be sure
that the key-way and pins
line up correctly.
Caution:
Do not force the plug
in. Excess force will cause
damage.
To disconnect the cable,
pull on the plug. Do not
pull on the cable.
3
Advertisement
Table of Contents
