Pairing The Remote Control; Ir Sensor - Philips 55PUS8601 User Manual

Uppercase and Lowercase
To type an uppercase character, press the  (Shift)
key just before you type the character.
To type several uppercase characters consecutively,
press and hold the  key while typing.
To type uppercase constantly, press the  key for 2
seconds to switch the keyboard in uppercase mode.
To switch out of uppercase mode, press the  key
again. If no keys are pressed for 20 seconds, the
uppercase mode switches off automatically. Also, if
you press another modifier key, like Fn or Ω, you
switch out of uppercase mode.
Numbers and Punctuation Characters
To type a number or punctuation character, press the
Fn key just before you type the number or
punctuation character you need. You can switch the
Fn mode on or off as you do for the uppercase mode.
Internet
You can use the Fn key to enter www. or .com.
Accented Letters and Symbols
Accented characters and symbols are not directly
available on the Remote Control Keyboard.
To type such a character, you can open the onscreen
keyboard.
To open the onscreen keyboard, press Ω. In the
onscreen keyboard, you can navigate to the character
you need. Switch the keyboard layout with the colour
keys. Press OK to enter a character. The onscreen
keyboard disappears when you press a character on
the Remote Control Keyboard.
Qwerty, Azerty and Cyrillic Keyboard
The standard layout of the Remote Control Keyboard
is Qwerty.
Azerty keyboard
Depending on your region, the Remote Control
Keyboard can be set to Azerty. The Azerty characters
are shown at the top right of the relevant keys.
To set the keyboard layout to Azerty...
1 - Press  SETTINGS, select All Settings and
press OK.
2 - Select Region and Language > Remote Control
Keyboard.
3 - Select Azerty or Qwerty and press OK.
4 - Press  (left) to go back one step or press 
BACK to close the menu.
Cyrillic keyboard
Depending on your region, the Remote Control
Keyboard can be switched to Cyrillic characters.
The Cyrillic characters are shown at the top right of
the keyboard keys.
To write Cyrillic characters...
1 - Press  on the remote control.
2 - Press  again to switch back to Qwerty.
6.5

Pairing the Remote Control

This remote control uses radio frequency (RF) to send
its commands to the TV. Contrary to remote controls
using infrared signals, you don't have to point at the
TV with RF. For the remote control to communicate
with the TV, both TV and remote control should be
paired (linked) with each other. Once paired, you
cannot use the remote control to control another TV.
Pairing
When you started the initial TV installation, the TV
invited you to press the OK key, and by doing so,
the pairing was done. If the TV does not react on any
remote control key press, pairing was unsuccessful.
Pair again
If the pairing with the remote control was lost, you
can pair the TV with the remote control again.
To start pairing...
1 - On the back of the TV, standing in front of the TV
at the right, press the joystick power key  in for 3
seconds. A message will show that the TV is ready to
pair.
2 - Press the colour keys
simultaneously for 1 second. A message appears
when the pairing is successful.
When you switch off the TV, the pairing is stored.
This TV can be paired with one remote control only.
To unpair the remote control from this TV, you must
pair it with another TV.
6.6

IR Sensor

The remote control of the TV uses RF (radio
frequency) to send its commands to the TV. With RF,
you do not need to point the remote control at the
TV.
However, the TV can also receive commands from a
remote control that uses IR (infrared) to send
31
(red) and (blue)
 