Remote Control Buttons - Philips 62PL9774/37B Directions For Use Manual

Hdtv monitor with pixel plus

Hide thumbs Also See for 62PL9774/37B:

Quick use and setup manual (8 pages)

Table Of Contents

Table of Contents

Select (CBL VCR DVD SAT AMP) and Backlight

Press this button to cycle across the accessory mode dial. Stop pressing

when the mode you desire is lighted. The light will stay on for 2 seconds

and then begin blinking to indicate the remote is in your desired mode.

As long as the button blinks, the remote is in the accessory mode. (See

pages 22–25 for programming the remote) Pressing and holding the

Select button for 2 seconds backlights the remote control buttons. The

buttons remain lighted for 5 seconds after you press Select.

Information Plus

Press to show information (when available) about the current channel,

program, source, number or name, local time, CC availability, SAP avail-

ability, program ratings, display format, sound mode, and remaining

length of a Sleeptimer setting.

Press to directly set the TV into the TV mode of operation.

CC (Closed Captioning)

Press to turn Closed Captioning off, on, or on during mute. (See page 47

in the Directions for Use manual.)

Surf

If you set the Surf control in the TV's on-screen menu to two channels,

this button will allow you to toggle between the current channel and the

last viewed channel. If you choose the nine-channel Surf, pressing this but-

ton allows you to add and scroll up to nine of your favorite channels. See

page 57 in the Directions for Use manual.

Press to activate or confirm menu choices.

Dual Screen/PIP (Picture-in-Picture)

Press to turn the PIP dual screen on or off. Continuing to hold the Dual

Screen/PIP button down will cycle through the Dual Screen/PIP options.

(See page 58 in the Directions for Use manual.)

VOL (Volume)

Press + or – to adjust the volume.

Mute

Press to interrupt or restore sound.

Source (AV+)

Press to display a list of source options—TV, AV1, AV2, AV3, AV4, AV5,

AV6, or Side. Use the Cursor Up/Down buttons to select the next item,

then press the OK button to confirm or press the Source (AV+) Select

button to select the next item in the list.

Alternate Audio (SAP)

When you tune to a channel where SAP (Second Audio Program) is

available, you can toggle between Main and SAP. If SAP is not available,

only Main can be selected. (See page 42 in the Directions for Use manu-

al.)

Active Control™ Plus

NOTE: Active Control™ Plus is not available for use with the AV3,

AV4, AV5, and AV6 input sources.

Press to toggle the options Off, Minimum, Medium, and Maximum.

Maximum is the recommended option. See page 28 in the Directions for

Use manual.

rights reserved.

*Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories.