Controls And Features - Cub Cadet RZT50 Operator's Manual

Controls and Features

Parking Brake
Throttle Control
Choke Control
Hour Meter/
Indicator Panel
Seat Adjustment Lever
Fuel Tank Cap
NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate that
position on the tractor when facing forward while seated in the
operator's seat.
Deck Height Index
The deck height index consists of six index notches
located on the front/right of the seat box frame. Each
notch corresponds to a 1⁄2" change in the deck height
position ranging from 1-1⁄2" at the lowest notch to 4" at
the highest notch.
Deck Lift Handle
The deck lift handle is located on the front/right of the
seat box frame, and is used to raise and lower the mower
deck.
Pull the handle to the left out of the index notch and push
downward to lower the deck, or pull upward to raise the
deck. When the desired height is attained, move the lift
handle to the right until fully in the index notch.
Deck Lift
Deck Height
Handle
Index
LH Drive RH Drive
Control Lever Control Lever
Figure 4-1
RH and LH Drive Control Levers
The RH and LH control levers are located on each side of the
operator's seat. These hinged levers pivot outward to open
space to permit the operator to either sit in the tractor seat, or to
dismount the tractor. The levers must be fully opened out and in
the neutral position to start the tractor engine.
Each lever controls the respective RH or LH transmission.
Consequently, these levers control all of the movements of the
tractor. Driving and steering utilizing these control levers is
quite different from conventional tractors, and will take some
practice to master. Refer to Operation for instructions on using
the control levers.
4
PTO Switch
Ignition Switch
Cup Holder
Storage Tray
11