Lamps; Buzzer - Epson fx-2180 Service Manual

FX-2180 Service Manual
Y
Micro Adjust ↑ / ↓
T
These switches are effective when the micro adjust function is enable
by Pause switch.
Micro Adjust function executes micro feed backward or forward by
1/216 inch.
T
TOF adjustment is enable in the TOF position after loading, and Tear-
off adjustment is enable in the Tear-off position.

1.2.1.2 Lamps

Y
Pause (Orange)
T
It is on when the printer is in pause, and it is off when the printer is on
line condition.
T
It blinks when the Micro Adjust function is enabled or printhead is in
hot condition.
Y
Paper Out (Red)
It is on when the printer is in the paper out condition, and it is off when
the paper is set in the printer.
Y
Tear Off / Bin (Green)
T
Only right LED is on when CSF bin1 is selected.
T
Only left LED is on when CSF bin 2 is selected.
T
Both LEDs are on when Card mode is selected.
T
Both LEDs blink when continuous paper is in the Tear-Off position.
T
Both LEDs are off when continuous paper is out of the Tear-Off
position.
Y
Font (Green)
The font LEDs consist of two LEDs. The current using font is shown by
these two LEDs on/ off combinations.
Y
Pitch (Green)
The pitch LEDs consist of three LEDs. The current using pitch is shown
by these three LEDs on/ off combinations.
Rev. A

1.2.2 Buzzer

This printer makes buzzer sounds when it discover error or illegal condition,
as listed below:
Y
Paper Out error
Approx.100ms buzzer sounds three times with two intervals of
approx.100ms.
Y
Cover open error
Approx.100ms buzzer sounds three times with two intervals of
approx.100ms.
Y
Release lever operation error
Approx.100ms buzzer sounds five times and approx.100ms interval is
four times.
Y
Illegal panel operation
One approx.100ms buzzer sounds.
Product Descriptions
1-9