Changing Feature Options - AT&T E2912 User Manual

1.
SETUP
until desired feature
is heard (see list at
right).
2.
SKIP or
REPEAT
until desired selection
is heard.
3.
SETUP
to set selection and
move to next menu
option.
- OR -
PLAY
to set selection and
exit menu.
NOTES:
1. The message alert tone will
beep only if all the conditions
below are met:
Answering system is on
Message alert tone setting
is on
Have new messages
2. Press any base key (except
RECORD, ANSWER ON
and HANDSET LOCATOR)
to temporarily silence the mes-
sage alert tone. If you press
and hold DELETE you will
delete all old messages and
the message alert tone will be
temporarily silenced. The mes-
sage alert tone will be re-acti-
vated with the next incoming
message.
Answering system operation

Changing feature options

You can change how the answering system oper-
ates. Press
When you hear the feature you want to modify press
SKIP
SETUP to set selection and move to next menu
option, or press
Feature options
System announces:
"Number of rings,"
current setting, then
"To change the setting
press SKIP or REPEAT;
to continue setup,
press SETUP."
Options: 2/4/6/toll
saver
"Base ringer," cur-
rent setting, then "To
change the setting
press SKIP or REPEAT;
to continue setup,
press SETUP."
/STOP
Options: high/low/off
"Remote access code,"
current setting, then
"To change the setting
press SKIP or REPEAT;
to continue setup,
press SETUP."
Options: (select two-
digit code) 19
"Message alert tone,"
current setting, then
"To change the setting
press SKIP or REPEAT;
to continue setup,
press SETUP." Options:
on/off
repeatedly to hear each feature.
SETUP
or to change the setting. Press
REPEAT
PLAY
(default settings underlined).
Feature description:
Choose number of rings before the sys-
tem answers a call. When toll saver is
active, the system answers after two rings
if you have new messages, and after four
rings if you have no new messages. When
retrieving messages from a long distance
call, you may disconnect your call after
three rings so that there will be no long
distance charge incurred.
Choose telephone base ringer volume to
high or low level, or turn the telephone
base ringer off.
Select a two-digit number (10-99)
for remote access from another tel-
ephone (page 43).
When on, the telephone beeps every
10 seconds when there are new mes-
sages.
38
/STOP to exit.
NOTE: Press and hold
REPEAT to increase or
decrease the remote access code
number by 10.
SKIP or