Recharging The Battery Pack - HP Pavilion DV1010 Series Hardware And Software Manual

Power
■
The system will not decrease hard drive speed while the
notebook is idle.
■
System-initiated Standby will not occur.
To fully discharge the battery pack:
1. Disable Hibernation. To disable Hibernation, select Start >
Control Panel > Performance and Maintenance > Power
Options > Hibernate tab. Then clear the Enable
Hibernation check box
2. Select Start > Control Panel > Performance and
Maintenance > Power Options > Power Schemes tab.
3. Record all settings in the Plugged In column and all settings
in the Running On Batteries column, so you can reset them
after calibration.
4. Use the drop-down lists to set each item in both columns
to Never.
5. Select OK.
6. Disconnect the notebook from the external power source,
but do not turn off the notebook.
7. Run the notebook on battery power until the battery pack is
fully discharged. When the battery pack is fully discharged,
the notebook is shut down.

Recharging the Battery Pack

1. Connect the notebook to external power and maintain the
connection until the battery pack is fully recharged and
the battery light is turned off.
You can use the notebook while the battery pack is
recharging, but the battery pack will charge faster if the
notebook is turned off.
2. If the notebook is turned off, turn on the notebook after
the battery pack is fully charged and the battery light is off.
4–28
.
Hardware and Software Guide