Yamaha RX-V2065 Service Manual page 42

RX-V2065/HTR-6295
3. HDMI AUDIO
Using the sub-menu, the audio signals input to HDMI IN are selected and output.
* When selecting "DSD", be sure to connect an HDMI unit equipped with DSD output function to this unit.
4. SPEAKER SET
The analog switch settings for each sub-menu are as shown in the table below.
FRNT : SML 0dB
CENTER : NONE
LFE/B : FRNT
Zone2/3 Amp ON
Bi-AMP
TONE : MAX
TONE : MIN
SPEAKER 6 ohms
LARGE: This mode is used for a speaker with high bass reproduction performance (a large unit).
Full bandwidth signals are output.
SMALL: This mode is used for a speaker with low bass reproduction performance (a small unit).
The signals of 90 Hz or less are mixed into the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3 dB and distributed to FRONT L/R.
SWFR: LFE of 5.1 ch signal or LFE/BASS lower than 90 Hz is output through SUBWOOFER OUT.
FRONT: LFE of 5.1 ch signal or LFE/BASS lower than 90 Hz is distributed to FRONT L/R.
42
SPDIF
3 . S P D I F
SPDIF signal is output.
Multi (DVD-Audio)
3 . M u l t i
Multi signal is output.
DSD (Direct stream digital)
3 . D S D
DSD signal is output.
FRONT CENTER
SMALL LARGE
LARGE NONE
LARGE SMALL
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
SURROUND SURROUND BACK
LARGE LARGE
LARGE LARGE
SMALL SMALL
– ( 1) – (
* *
LARGE LARGE (
LARGE LARGE
LARGE LARGE
LARGE LARGE
( * 1) ZONE2/3 L/R (EXTRA SP1/2 L/R): LARGE
( * 2) Bi-AMP: LARGE
SUBWOOFER
SWFR
SWFR
FRONT
1) SWFR
* 2) SWFR
SWFR
SWFR
SWFR