Table of Contents
Advertisement
CS-ME7EB1E / CS-ME10EB1E / CS-ME12EB1E / CS-ME14EB1E
10.6. Other Indoor Unit Operation Functions
10.6.1. Auto button
Proceed with operation when the air conditioner is stopped.
(When the auto button is pressed during operation, the air conditioner is stopped.)
1. Emergency operation
Press the auto button and release it within 5 seconds to perform emergency operation.
Under normal condition (failure is not occurred) automatic operation is performed. In the event of a failure that still enables
operation to be performed, emergency operation is performed.
2. Forced cooling operation
Keep pressing the auto button until one beep sounds to perform the automatic cooling operation.
The air conditioner does not operate for 2 minutes if the room temperature is low (intake temperature below 16 °C) so
just wait. The forced operation is performed after the 2 minutes have elapsed.
3. Forced heating operation
First press the auto button until one beep sounds, and then set it to OFF.Now press the auto button until two beeps sound to
perform the automatic heating operation.
4. Select Remote Control Transmission Code
· There are 4 types of remote control transmission code could be selected and stored in EEPROM of indoor unit. The indoor
unit will only operate when received signal with same transmission code from remote control. This could prevent signal
interference when there are 2 more indoor unit installed nearby together.
· To change remote control transmission code, short or open jumpers at the remote control printed circuit board.
24
Hide quick links:
Advertisement
Table of Contents
