Advertisement
91-5661-20-00.E250.R0.qxd
Battery installation & charging
Install batteries as shown, then place the handset in the charger for at least 8 hours
before use. You can keep batteries charged by returning the handset to the charger after
each use. When battery power is fully depleted, a full recharge takes about 6 hours.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
To replace battery cover
Insert top
tab first.
02/13/1950
19:21
Page 2
Plug power cord into jack on underside
of charger, then plug transformer into
electrical outlet.
Press down to
click in place.
Place handset in charger to
charge for 8 hours before first use.
Light remains on while batteries
are charging.
2
LOW BATTERY
REDIAL
MENU
MEM
Low battery indicator
Return handset to charger to recharge
when this symbol flashes. (Handset
will beep when battery is low.)
Insert supplied
batteries.
Caution: Use only the supplied
NiCd battery (80-5469-00-00)
or AT&T model 2AA NiMH
replacement battery (SKU
26820). Do not use alkaline
batteries.
Advertisement
