Cleaning Tools - Hoover TurboPOWER Owner's Manual

2-5
B
Carpet height adjust-
ment
When it is necessary to raise and lower the
f ront of the cleaner (A) for various carpet
pile heights, slide the carpet height contro l
( B ) to the correct setting.
2-7
Edge cleaning
Edge cleaning is provided on both sides
of the front of the cleaner to help remove
dirt in carpet near baseboards and furni-
ture. Guide either side of the cleaner
parallel to the edge of the carpet or fur-
niture.to edge of carpet or furniture.

Cleaning tools

Tools allow you to clean surfaces above
the floor and reach hard to clean areas.
Use tools with the cleaner handle in
upright position.
C AU T I O N : Agitator continues to ro t a t e
while cleaner handle is in upright
p o s i t i o n . Avoid tipping cleaner or
setting it on furniture, f r i n ged area
r u g s , or carpeted stairs during tool
u s e.
How to clean tools
To clean the hose, wipe off dirt with a
cloth dampened in a liquid detergent.
Rinse with a damp cloth.
Cleaning tools may be washed in warm
water with a detergent. Rinse and air
dry before using.
8
2-7
A
For ease in sliding the control, the han-
dle should be in the upright position.
The front of the cleaner will not move
into the adjusted position until the
handle is lowered to the operating
p o s i t i o n .
2-8
Cleaning lightweight
flexible rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) and will prevent rug from
clinging to cleaner.
Continue to lift front of cleaner so that
when you have reached the edge, it is
completely off the rug. Move cleaner
back to start again, lower front of
cleaner, and use only forward strokes.
2-10
A. Attach hose to
cleaner
Turn cleaner OFF before attaching or
removing hose.
With cleaner handle in upright position,
open hose door and insert hose connec-
tor until locked in position. Suction will
For maximum cleaning perfo r m a n c e,
the following carpet height settings are
re c o m m e n d e d .
• Lowest setting 1: for bare floors and low
pile, level loop, kitchen type carpet.
• Next setting 2: for other types of carpet •
• Higher settings (3-4): for very deep pile
carpet where easier pushing eff o rt is
d e s i red, while maintaining good cleaning
p e rf o rm a n c e .
N o t e : If the cleaner is difficult to push,
slide the control to the next higher setting.
2-9
Stair cleaning
A stair cleaning handle has been
designed for ease in using your cleaner
on stairs.
With handle in operating position, place
fingers under edge of stair cleaning
handle and guide cleaner with other
hand on upper handle.
As an alternative, you may use the hose
and furniture nozzle for stair cleaning.
When using cleaning tools, the
agitator will continue to rotate.
CAUTION:To avoid personal injury or
unnecessary wear to carpet, and to
prevent the cleaner from falling, use
extra care if cleaner is placed on
stairs.
automatically be diverted to the hose
when cleaner is turned ON.
To remove hose, press latch (C) on hose
connector and pull up.
Note: Hose must be removed from
hose door when cleaning carpet and
rugs to insure proper cleaning perfor-
mance.
C