General - Sony ZS-YN7 Service Manual

Basic Operations
Playing a CD
1
3
Connect the supplied AC power cord
1
Press OPEN to open the CD lid
(direct power-on) and place the CD
on the CD tray.
Note
Make sure that the CD is placed properly
on the CD tray. Don't place it under the
CD tray.
2
Press PUSH CLOSE to close the CD
lid.
6
To
select a group*
select a file*
remove the CD
turn on/off the player POWER
2
* You can operate during play of ATRAC CDs/MP3 CDs.
* 3 Once you open the CD tray, the track to start play will change to
the beginning of the first track.
The structure of ATRAC CDs/MP3 CDs
Notes
ATRAC CDs/MP3 CDs consist of "files" and "groups." A
• If ATRAC3plus/ATRAC3
files and MP3 files are "file" is equivalent to a "track" of an audio CD. A "group"
recorded on the same CD,
is a bundle of files and is equivalent to an "album."
this CD player plays the
For MP3 CDs, this CD player recognizes an MP3 folder as
ATRAC3plus/ATRAC3
a "group" so that ATRAC CDs and MP3 CDs can be
only.
operated in the same way.
• The playback capability of
this CD player may vary
depending on the quality of Playing order of ATRAC CDs and MP3 CDs
the disc and the condition of
For ATRAC CDs, files are played in the order selected in
the recording device.
SonicStage.
• Characters that can be
For MP3 CDs, the playing order may differ depending on
displayed on this CD player
the method used to record MP3 files on the disc. In the
are listed below.
following example, files are played in order of 1 to 7.
– A to Z
– a to z
Group
– 0 to 9
File
– ! " # $ % & ' ( ) * + , - . / :
; < = > ? @ [ \ ] ^ _ ` { | }
ATRAC CD
~
If you use other characters
on your computer using
software such as
SonicStage, they are
displayed as "–" on this CD
player.
• On a disc that has
ATRAC3plus/ATRAC3/
MP3 files, do not save files
in other formats and do not
make unneccessary groups.
8
SECTION 2
2
With the label side up
Press
2 + to go forward and – to go
backward
2 > to go forward and . to go
backward
OPEN* 3
MP3 CD

GENERAL

3
Press u (N on the remote).
The player plays all the tracks once.
Track number
Note
Before playing an ATRAC
CD/MP3 CD, this player
reads all file and group
information on the CD.
Depending on the file
structure, it may take more
than a minute to read them.
During this time, "Reading"
is displayed.
Tips
• To listen through
headphones, connect the
headphones to the i
(headphones) jack.
• Playback starts from the
point you last stopped
playing (Resume play).
During stop, the point to be
played is displayed.
To cancel the resume play
to start play from the
beginning of the first track,
press x in stop mode.
This section is extracted from
instruction manual.
Display
Audio CD ATRAC CD/MP3 CD*
Playing time
File number Playing time
* When playing an MP3 CD, "MP3"
appears in the display.
Use these buttons for additional operations
POWER
u
x
+, –
VOLUME +, –
>
.
OPEN
To Press
adjust the volume VOLUME +* 1 , – (VOL +*
remote)
stop playback x
pause playback u* 1 (X on the remote)
Press the button again to resume play after
pause.
go to the next track >
go back to the .
previous track
1
* The button has a tactile dot.
Notes on ATRAC CDs
• Maximum number of groups: 255
Maximum number of files: 999
• CD-Rs/CD-RWs recorded in the ATRAC3plus/ATRAC3 format
cannot be played on your computer.
Notes on MP3 CDs
• Maximum number of groups: 100
Maximum number of files: 400
Maximum directory level: 8
• A group that does not include an MP3 file is skipped.
• Be sure to add the file extension "mp3" to the file name.
However, if you add the file extension "mp3" to a file other than
an MP3 file, the player will not be able to recognize the file
properly.
• This player can play bit rates of 16 to 320 kbps, and sampling
frequencies of 32/44.1/ 48 kHz. Variable Bit Rate (VBR) file
can also be played.
• To compress a source in an MP3 file, we recommend setting the
compression parameters to "44.1 kHz," "128 kbps," and
"Constant Bit Rate."
• To record up to the maximum capacity, set the writing software
to "halting of writing."
• To record to the maximum capacity at one time up on media that
has nothing recorded on it, set the writing software to "Disc at
Once."
ZS-YN7
File name
1 , – on the
continued
7
9
5