Dimplex WRCPF-KIT Owner's Manual page 10

Wall Control Installation
its Outer Housing by pushing
the front face into the Outer
Housing until you hear a click.
This will release the push-lock
latches and allow the Control-
ler to be removed from the
Outer Housing (Figure 5).
3. Push the wire lead storage
compartment cover on the
back of the Control towards
the right (as shown), and re-
move (Figure 10).
4. Uncoil the two wire leads and
feed each of them through one
of the two holes located on the
wire lead storage compartment
cover (make sure orientation is
as shown as in Figure 11).
5. Replace the wire lead storage
Figure 10
10
Figure 11
compartment cover on the
Controller with wire leads fed
through and exposed.
6. Feed the two wire leads from
the Controller through the two
holes in the back of the Outer
Housing as shown in Figure 12.
7. Gently pull the wire leads
through while pushing the
Controller into the Outer Hous-
ing until you hear the push
lock latches click, locking the
Controller in place (Figure 13).
Locking Screw Option (Figure 14)
To prevent tampering, dam-
age, and theft, it is suggested to
install the locking screws. Once
installed, the locking screws will
prevent the Controller from being
released from the Outer Housing
www.dimplex.com